Home >

Cleaning Method For Needle Checking Machine

2012/9/19 16:40:00 19

CleaningNeedle Checking MachineConveyor Belt

 

Because

Needle machine

It is a highly sensitive testing instrument, so there are relatively strict requirements for the maintenance of the working environment and machinery.


Usually after a period of time, there will be some common "troubles" in the needle checking machine, so we should regularly clean the conveyor belt parts and other easily damaged parts while in normal use.



The specific cleaning methods and matters needing attention are as follows:


1. cleaning utensils: find a clean towel and wring it until wet.


2. cleaning the surface of the conveyor belt: attention should be given to the sensitivity of the needle checking machine to the lowest level before cleaning.

If there are 1 to 10 grades of needle checking machine, please adjust the needle checking machine to the lowest level 1 level mode, so as not to be too sensitive to affect the next step of cleaning work.


Then, we straightened the towels and pressed them on the surface of the conveyor belt properly, and started the machine to make the machine run for more than five cycles. The purpose was to clean the contaminants on the surface of the conveyor belt, and the method could be applied flexibly. Then, wash the towels and dry them, repeat the cleaning steps again and then wipe the conveyor belt.

Conveyor belt

There is no obvious contaminant on the surface.


3. cleaning the back of the conveyor belt: we can remove the metal shell on the left and right sides of the conveyor belt, then wash the towels and wring them dry, and push the towels through the bottom of the conveyor belt, straighten the towels, grasp the two ends of the towels, and start the machine to run the machine for several weeks.

Because the bottom of the conveyor belt is the dirtiest part, it needs to be cleaned repeatedly. After several weeks of operation, the towel should be washed and cleaned, and then repeat the cleaning steps again.


If we clean up the above steps, we still find that the probe lights are blinking continuously after the needle machine is turned on, and the clothes can not pass smoothly. The above cleaning steps should be repeated again.


At the same time, it is worth noting that we are carrying out the needle checking machine.

clean

In the post test work, special attention should be paid to avoiding environmental factors such as personnel walking, too large machine distance and so on.

  • Related reading

Knowledge Of Four Arm And Six Wire Sewing Machine

Equipment matching
|
2012/9/19 16:14:00
97

How To Repair The Needle Jumping Fault Of Round Head Keyhole Machine

Equipment matching
|
2012/9/19 15:10:00
132

Development Of Garment Template Technology

Equipment matching
|
2012/9/19 13:49:00
23

Functional Features Of Computerized Embroidery Towel Embroidery Series

Equipment matching
|
2012/9/19 11:29:00
21

How To Disassemble Sewing Machine Winder

Equipment matching
|
2012/9/19 10:44:00
48
Read the next article

Home Textile Industry Is "Hurt" Because Of High Cotton Prices.

This year, affected by the economic environment, the growth rate of home textiles market continued to slow down. Cotton prices rose at the beginning of last year, resulting in price increases for home textile enterprises and an increase in performance contribution. This year, raw material prices are relatively stable, home textile enterprises support growth in volume, and the slowdown is normal.